Step 1 Plug the power cable plug into the power supply socket on site to ensure the normal power supply. One-key boot: Turn the key, press the next start button, wait for the system to automatically start and enter the operation interface. Step 4 Check whether there are some goods in the equipment channel, if any, please clear it out of the channel.

If the conveyor belt position obviously deviates from the channel center (its edges are stuck in the guard boards on two sides) or the belt has insufficient tension (the conveyor surface is loose), the operator should adjust the conveyor position under the guidance of professionals, or read the maintenance manual carefully. Step 3 Check and make sure that the surface of the belts should be no cracks, and a certain distance should be reserved between the conveyor belt edge and the guard boards on two sides check whether belts are deviated or stuck. If there are the excessive gaps between the curtains or the lead curtains are seriously damaged, please stop operating equipment and contact the local after-sales service department.

Step 2 Check whether the lead curtains at the channel inlet and outlet which are used to prevent the X-ray leakage are in good condition the door curtains should be free from the obvious gaps and obvious damage If you find the damaged cable sheath, failure of the Emergency Stop button or unsmooth special keyboard, please stop operating the equipment and contact the local after-sales service department.

How to install xray